radion koodin syöttäminen

[jhallis1]

Juu elikkäs pssatin vm.98 alkuperäsen radion koodin runkaaminen radioon ? koodi on tiedossa.

[tos]

tuosta en tiedä mitään, mut voisin veikata koodin syöttämisestä seuraavaa.
Painele nappulaa 1. kunnes näyttölle vaihtuu koodin ensimmäinen luku.
Toista sama nappulalla 2.
sama napilla 3
ja 4

[jhallis1]

Ja mites se kuitataan? Painetaan kahtanappulaa yhtäaikaa?

[tos]

Ööh en tiedä :D mitä radion paneelissa lukee, gamma, beta?

[jhallis1]

gamma

[tos]

ööh, toivottavasti tuo auttaa:

Input the code number attached to the code card using the station buttons. Use button 1 to input the first digit of the code, button 2 the second etc etc.

then press either the search or the manual setting rocker switch for longer than 2 seconds. Then release the button.input the first digit of the code, button 2 the second etc etc.

tuossa viel toiset
Entering anti-theft code

The following is the procedure to re-activate the radio if the display shows "SAFE". It is important that the procedure be followed in the correct order.

Turn on radio. The radio display shows "SAFE".
Press the FM1 and AM buttons simultaneously and hold until "1000" shows on the display. Release the buttons. Do NOT press these buttons again, otherwise the radio will consider "1000" to be the code.
Use Preset buttons 1 ... 4 to enter the four-digit code number from your radio card. Preset button 1 corresponds to the first digit, Preset button 2 corresponds to the second digit, etc. Each press of the button increments the number by 1.
Once the code shown on the display is correct, press the FM1 and AM buttons simultaneously and hold until the word "SAFE" appears in the display, then release the buttons.
The radio should unlock and be usable shortly afterwards.
If an incorrect code is entered, the word "SAFE" appears, first flashing and then continuously. You can repeat the above steps to unlock the radio once more, the number of attempts will be shown in the display. If an incorrect code is entered again, you radio will be locked for about one hour. After one hour - the radio must stay on and the key must remain in the ignition lock - if the display goes out, the you can repeat the above procedure to unlock again. The cycle - two attempts, one hour lock-up - still applies.
If you lose your radio code, contact your Audi dealer

.

[jhallis1]

ööö, tänks...toimii :)