eli beetle antaa seuraavat vikakoodit,
Steering angle sensor G85 static no or incorrect setting
Steering angle sensor G85 static mechanical malfunction
Steering angle sensor G85 sporadic implausible signal
Rattiakselin tunnistin on vaihdettu uuteen mutta vaatiiko se jonkin sopeutuksen jne volkkarilta kun tuolla omalla testerillä ei sinne rattiakselin valikkoon pääse nollaan koodeja.
Samalla syttyy myös ABS valo mutta kuittaantuu kun sammuttaa auton.
Öisko ideoita... tietäjälle tarjoon kahvit.
Esp vikakoodeja, viisaita kaivataan..mm. g85
Valvoja: ffp jäsenet
-
- -
- Viestit: 362
- Liittynyt: 21.9.2003 13:17
Sensor for Steering Angle (G85)
Prerequisites:
Start the vehicle.
Turn the steering wheel one turn to the right and one turn to the left.
Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.
Ensure that the steering wheel is not moved again.
Keep the engine running and do not switch off the ignition.
System voltage at least 12.0 V.
[Select]
[03 - Brake Electronics]
[Coding-II - 11]
Enter 40168, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 060
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 2 should say "OK".
[Done, Go Back]
To make sure the basic setting was succesful, check the sensor again.
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 1, the value has to be between -4.5 and +4.5 °.
[Done, Go Back]
[Close Controller, Go Back - 06]
Voisko toi toimia tohonki laitteeseen?
Palaa sivulle “Tekniikka - Bensa”
Paikallaolijat
Käyttäjiä lukemassa tätä aluetta: Ei rekisteröityneitä käyttäjiä ja 69 vierailijaa